Set the decision boundary
Confirm battery serial and specification first, then obtain state-of-health data where available, cell-voltage spread, fault history, temperature behaviour and charge records.
Energy compatibility is a system, not one range number. Battery, connector, voltage, communication, route and destination support must work together.
Evidence to request
Inspect the pack enclosure and underbody for impact, deformation, scraping, corrosion, coolant evidence and unapproved repair. Test charging under controlled conditions.
A physical match without electrical and service compatibility is not an approved pathway.
What can invalidate the conclusion
A cleared warning lamp, recently reset estimate or one short drive cannot establish usable capacity or exclude intermittent isolation and thermal faults.
Resolve contradictions at source. Record the market, model year, test condition and quotation period beside any claim that depends on them.
Confirm battery serial and specification first, then obtain state-of-health data where available, cell-voltage spread, fault history, temperature behaviour and charge records.
A modestly used car with stable diagnostics and clean underbody evidence can be preferable to a lower-mileage car with missing battery history.
Record transport state of charge, carrier requirements and destination access to qualified high-voltage diagnosis before accepting residual uncertainty.
Turn the claim into an auditable vehicle record
Run the energy review as a chain from battery and powertrain labels to the destination socket. Record rated values, physical inlet, communication standard, onboard equipment, charge-session result and any proposed adapter. Then map home supply, public networks, climate, daily route and qualified repair access. Keep published range separate from the reserve used for a real route. If electrical limits, protocol or battery condition remain unknown, the vehicle is not yet comparable with a locally supported alternative and should stay on hold.
For this decision, assign a source, date, reviewer and refresh point to every required field. The six controls below are not complete when merely mentioned in a sales message; each needs evidence strong enough for another reviewer to reach the same conclusion.
01 Battery identityCapture the original record and check it against the selected VIN.
02 Diagnostic health dataRecord the test method, result, limits and person responsible for follow-up.
03 Cell balanceState the destination consequence, cost exposure and approval status.
04 Underbody conditionCapture the original record and check it against the selected VIN.
05 Charge testRecord the test method, result, limits and person responsible for follow-up.
06 Repair historyState the destination consequence, cost exposure and approval status.
Before approval, read the file without relying on the original salesperson’s memory. Mark every unresolved item as a hold, give it an owner and deadline, and repeat affected checks when the vehicle, quotation, route or destination rule changes. This distinguishes a documented A06 candidate from a plausible but unverified listing.
Keep rejected evidence in the file with the reason it was rejected. This prevents an outdated screenshot, superseded quotation or mismatched brochure from returning later as if it were current proof, and it gives the destination receiver a clear audit trail.
Connect the result to the destination
Record transport state of charge, carrier requirements and destination access to qualified high-voltage diagnosis before accepting residual uncertainty.
Record the responsible party, evidence date, expiry or recheck point and the effect on cost or approval. A complete file makes remaining uncertainty visible; it does not turn an unknown into a confirmed feature.
Use the result in a buyer scenario
A modestly used car with stable diagnostics and clean underbody evidence can be preferable to a lower-mileage car with missing battery history.
Finish with pass, hold or reject. A hold should name the missing evidence, owner and deadline. A replacement VIN begins a new review rather than inheriting approval.
Check Nevo A06 Battery Health Before Export: evidence checklist
- Battery identity
- Diagnostic health data
- Cell balance
- Underbody condition
- Charge test
- Repair history
Questions to close before approval
Can range shown on the screen prove health?
No. It depends on recent use and software estimation.
Should the battery be opened for inspection?
Only by qualified personnel under an appropriate procedure; routine buying checks should avoid unsafe intrusion.
What if health data is unavailable?
Increase diagnostic and charge testing, price the uncertainty or reject the candidate.